EV Charger Installation
Level 2 chargers on a circuit sized to your panel, not to a guess. We check the load first and tell you if a smaller fix will do.
How we handle itPermits pulled and inspections booked on every install · (000) 000-0000
Hunts Point, Washington
EV chargers, panel upgrades and remodel wiring, matched to what your house actually draws, with the permit and the inspection handled for you.
Walk through your options — (000) 000-0000
Nine kinds of work, one standard for all of them: a load check first, a written scope second, and nothing energized until it has been tested. Pick the job closest to yours to see how we handle it, what the visit involves and how long the work usually takes.
Level 2 chargers on a circuit sized to your panel, not to a guess. We check the load first and tell you if a smaller fix will do.
How we handle it
Kitchens, baths and additions wired around your contractor's schedule, with new circuits planned before the walls close.
How we handle it
Old cloth-insulated, ungrounded or aluminum branch wiring replaced room by room, with the least disruption we can manage.
How we handle it
Their own breaker and wire for the appliances that trip shared circuits: ranges, heat pumps, freezers, workshop tools.
How we handle it
Burning smell, sparking outlet or half the house dark? Call during office hours and we move urgent faults to the front of the schedule.
How we handle it
Full panels, recalled brands and 100-amp services replaced only when the load calculation says it is time.
How we handle it
Complete wiring for new homes, ADUs and major additions, from service sizing to final inspection, on the builder's timeline.
How we handle it
Recessed, pendant, under-cabinet and exterior lighting placed for how you use each room, with dimming that does not flicker.
How we handle it
Tripping breakers, dead outlets and flickering lights traced to the actual cause, then repaired once.
How we handle it
A charger, a heat pump or a new kitchen can push a panel past what it was built for, and the cheapest fix is the one that matches the real load. These four habits are how we keep the work right-sized and safe.
We run the numbers on what your house draws before recommending anything. If your existing service can carry a new charger with a dedicated circuit, we say so, and you skip a panel upgrade you never needed.
Every installation that needs a permit gets one, filed by us. We schedule the inspection and meet the inspector, so the work is on record when you refinance or sell.
Electrician Hunts Point is licensed, bonded and insured in Washington State, and the electrician who leads your job brings ten years of hands-on electrical experience to it. Nobody unqualified is left alone with your wiring.
Drywall dust is vacuumed, cover plates go back square, and every circuit we add is written into your panel directory. You can tell which breaker feeds what without guessing.
Four steps, the same on a single circuit or a full remodel. You always know what happens next and what it costs.
Describe the charger, the remodel or the fault on the phone. We ask a few questions about your panel and service size and book a time that suits you.
At the free in-home estimate we open the panel, trace the route the new wiring would take and talk through two or three ways to do it. Most visits take under an hour.
The quote lists each task, the materials and the permit, with one price for the whole job. Nothing is added later without your say-so in writing.
We do the work, test every circuit, book the inspection and show you what changed, including the new entries in your panel directory.
Our home base is Hunts Point, at the end of Hunts Point Road on its own small peninsula, and the same crew covers the neighbouring Points communities and the east shore of Lake Washington. SR 520 links the whole area, so a visit to Yarrow Point, Medina or Kirkland follows the same routine as one at home.
From the Points to Bellevue Way the routes are short and familiar, so we arrive in the window we gave you with the parts for your job already on the van.
Whether the job is in Clyde Hill or Redmond, the steps are identical: load check, written scope, permit, test, inspection.
Every town on this page books through (000) 000-0000. Tell us the address and we will confirm the visit before we hang up.
Not sure your street is on our list? Call and ask; the answer takes ten seconds.
Check your address — (000) 000-0000Call before you order equipment. A ten-minute conversation and a free look at your panel can tell you whether you need a new circuit, a load-management device or a bigger service.
Book the free estimate — (000) 000-0000We quote in writing after we have seen the panel, never sight unseen.
Straight answers to the questions that come up most before a job is booked.
Almost always, yes. We check your panel's spare capacity, measure the run from the panel to the parking spot and recommend a circuit sized to the charger you have chosen. If the panel is tight, a load-management device is often cheaper than a service upgrade.
We do. Electrician Hunts Point files the electrical permit for every job that needs one, books the inspection and is there when the inspector arrives. You get a finished job that is on record with the city.
It depends on the amperage you move to, whether the meter base and service entrance change, and how far the panel sits from where it needs to go. After the free in-home estimate you get one written price that covers parts, labor, permit and inspection.
Yes. The in-home estimate costs nothing and carries no obligation. We look at the panel, ask what you are planning and leave you with options; the written quote follows once we have seen the job.
Installations carry a two-year workmanship warranty on the labor. If a connection, device or termination we installed fails because of how it was installed, we come back, evaluate it and correct it with no additional labor cost. Manufacturer defects, wear, damage and problems in wiring we did not touch are not covered; the equipment makers' own warranties apply separately.
Usually it is an overloaded circuit, a failing device or a loose connection somewhere along the run. We test the circuit under load and trace it until we find the actual cause, rather than swapping the breaker and hoping.
Both brands have a long record of breakers that may not trip when they should, and many insurers and home inspectors now flag them. If yours is one, we will show you what we see inside it and price a replacement so you can decide with the facts in front of you.
One visit, one written scope and one price you can hold us to. Call to set up your free in-home estimate in Hunts Point or nearby.
Set up the walkthrough — (000) 000-0000Office hours are on our Contact page.